The impeller of a high-pressure fan consists of dozens of blades, which is similar to the impeller of a huge gas turbine.
The air between the impeller blades is subjected to centrifugal force and moves to the edge of the impeller, where the air enters the annular cavity of the pump body, and recirculates in the same way from the starting point of the blade.
The circulating air flow generated by the rotation of the impeller leaves the air pump with extremely high energy for use. The fan adopts a special motor, which is compact in structure, small in size, light in weight, and low in noise. The air supply is free of water and oil.
Due to the complexity of the structure of the high-pressure blower, its parts and accessories need to be disassembled during maintenance, otherwise the purpose of cleaning and maintenance cannot be achieved, which means that the service life of the equipment cannot be effectively increased.
But disassembly also needs to pay attention to steps and sucking. In this process, if you are not careful, some parts will be worn to different degrees, resulting in incomplete integration during assembly.
When disassembling, it must be done step by step. After all the parts of Fengxian are disassembled, these parts must be cleaned one by one, and some special detergents are also used in this process.
At the same time, pay attention not to damage the spare parts. When entering the assembly process, be sure to check whether the moisture of the spare parts has been completely dry, and do not assemble in the presence of moisture.
The cleaning method of the filter screen of the high-pressure fan is mainly based on the degree of pollution, so before the operation, the pollution must be not serious, and if it is serious, it can be replaced directly.
But if it is not very dirty, washing with water can achieve the desired effect, or using a vacuum cleaner to remove dust particles on the surface of the filter.
Be careful and meticulous when cleaning. If you find that the filter has been deformed, you need to replace it with a new one. Another important point is the cleaning cycle, which is one of the important guarantees for the good operation of the blower.
During the use of the fan, once the equipment has excessive pressure, in order to ensure the safety of relevant operators,
The correct operation method is: stop the inflation operation immediately, let the air pressure drop to some extent before proceeding, if necessary, you can also reduce the pressure by opening the air method.
For the automatically controlled high-pressure fan, you can rest assured, because the internal pressure of the air pump will automatically respond after reaching the preset value and stop running.
In actual operation, try to observe the status of the equipment as much as possible, and find that the problem must be solved immediately, so that the risk factor can be reduced to a very low level.
